Bobcat of the Rockies

An employee was loading a dish washing machine. A plate bumped against the machine and broke, lacerating the employee's left arm. The employee was hospitalized and required surgery.

An employee was throwing a mirror into a dumpster when the mirror shattered and lacerated the employee's arm.

Two Rycon employees were installing glass marker boards in a nearly completed space. Each employee had a suction cup on the face of the board and a hand on the bottom of the board. Upon hanging the third board in sequence on a hang strip mounted to the wall, the board needed to be moved about half an inch to butt tightly to the adjacent one. When the employees moved the marker board, it shattered causing half of the board to fall and cause a severe laceration to an employee's left wrist.

On May 15, 2023, an employee removed a mirror from the bathroom to discard it. As the employee went to place it on the cart, the mirror broke. The employee sustained a laceration on the right forearm that required surgery.

An employee was lifting a round, glass table top while working on a waste collection route. The glass table top shattered and lacerated the employee's arm.

An employee was working behind a stack of steel I-beams (stacked 2 columns deep and 4 levels high on the floor) while a forklift was pushing the stack. When the forklift took off the second-to-last beam, the last one was pushed over, causing it to fall to the ground and strike the employee. The employee sustained a fracture to the right leg.

An employee was lifting a flat sub (sheet steel) in the flats robot cell (weld area). He was operating a hoist when his left little fingertip got caught between the lifting device hook and the flat sub. The employee sustained a partial transphalangeal amputation.

An employee was underneath a 35-foot boom truck and adjusting the transmission linkage when the truck jumped over the wheel chocks and rolled over the employee's right leg, resulting in a fracture.

A crane was being used to lift a debris tank from a rack. The tank crushed the employee's right hand, causing amputations to the employee's right ring finger and little fingertip.

An employee was removing a small sheet metal part out of the die of the brake press. The foot pedal was pressed, causing the part to lift and crush their left thumb against the die. The employee suffered an amputation to the thumb tip including the loss of flesh and the fingernail.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.