The Lane Construction Corporation

As an employee was moving on the top of a retaining wall when he fell 16-20 feet due to loose soil. He sustained fractures to lower back vertebrae.

Two employees removed a portable generator from the back of a truck and carried the generator to a cargo container. When they set the generator down the injured employee's right little finger was pinched between the cargo container and the frame of the generator, resulting in a partial amputation of the fingertip.

An employee was using a chipping hammer to remove concrete from an existing barrier section when the tip of his left index finger was pinched between the edge of the concrete and the chipping hammer. The employee's fingertip was amputated.

An employee was changing a cartridge on an epoxy gun. The employee used a razor knife to cut the cartridge tip and amputated their little fingertip.

An employee was assisting with the movement of a plate compactor using an excavator with a strap connected to the bucket. The excavator bucket fell off and the plate compactor struck the employee, resulting in a broken left femur and foot.

An employee was riding on a powered pallet jack near a sewer drain. The pallet jack hit a dip near the sewer drain, and the employee s left foot hit a clamp truck parked in a charging station. He suffered a cut to the big toe, as well as fractures in the toe and the foot.

An employee went to step off material handling equipment to grab their jacket when the throttle of the vehicle engaged. The vehicle reversed and the employee's left foot was crushed between two material handlers, resulting in a fracture.

An employee was working at a height of approximately 20 feet and was standing outside his forklift's basket attachment. His forklift was struck by another forklift, causing the employee to fall to the warehouse floor below. The employee sustained facial injuries, broke two ribs and an arm, and also suffered a head injury. The employee was wearing a harness at the time but it was not connected to an anchor point.

On November 8, 2023, an employee was operating a stand-up pallet jack in the warehouse. As he was backing up, the pallet jack struck the basket of a parked aerial lift. His right ankle became caught between the pallet jack and the aerial lift basket resulting in a fractured ankle.

On October 26, 2023, at approximately 12:00 PM, an employee operating a four wheeler was on their way to an off-property break location. The employee stopped the four wheeler near the administrative office to allow a log truck to exit the property. The log truck backed up, and the employee's left ankle was caught between the log truck trailer and the four wheeler, resulting in a fracture and laceration.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.