McCain Foods USA, Inc.

An employee was putting a machine guard back onto a chain and sprocket when their left middle finger became caught in the chain and sprocket. The employee sustained an amputation of the fingertip.

On December 3, 2024, at approximately 11:30 PM, electronic technicians were adjusting a tensioning chain on an elevator on a palletizer that had become unlevel. After loosening the tensioners and creating slack in the chain, the injured employee was placing the tensioning chain back onto the sprocket. While moving the chain it regained tension and their left middle fingertip was caught between the chain and the sprocket and was amputated.

An employee was cleaning jammed potatoes from the top of a roll sizer in the raw receiving area when her right index finger was caught in the chain, resulting in hospitalization and a fingertip amputation.

On December 12, 2023, at approximately 3:00 a.m., an employee was unplugging a drain with a powered snake tool when his left hand was caught in the snake cable. The cable pinched his left ring finger, resulting in a fracture and partial fingertip amputation.

On September 8, 2023, an employee was on break when they slipped on the floor and fell on their right hip. Their hip was fractured.

An employee was using a crane. The hook slipped and a fitting fell onto a finger on the employee's left hand causing a fracture and laceration.

An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.

An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.

An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.

An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was performing maintenance under a kettle. When he removed a tri-clamp on a transfer line, the hot fat and broth material in the kettle poured out onto his arm. The employee was hospitalized with burns.

An employee was walking on top of boiler to close a valve. The employee fell off the boiler and landed on the floor, sustaining fractured ribs. The employee was hospitalized.

An employee was inspecting a pipe in the rice cooking area near an oven. While checking for a clog, the fingers of their right hand were caught in an airlock at the base of the pipe. All the fingers were amputated except the thumb. The employee was hospitalized.

An employee was removing dough from the discharge at the bottom of a mixer when the scraper contacted his left index finger and amputated it.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.