LARSON MANUFACTURING

An employee was drying and finishing vehicles when a vehicle door closed on their left middle fingertip and amputated it.

An employee was climbing down from a tractor trailer bed when they lost their footing and grabbed onto the roll-up door to stop the fall. The roll-up door then fell onto the employee's hand, resulting in a hand fracture that required surgery.

An employee was attempting to remove a tarp from a flatbed trailer when the trailer handle struck the employee in the chest, resulting in two broken ribs and a punctured lung.

An employee was near a backhoe while the operator was getting a broom. The broom handle struck the lever that actuates the swing of the backhoe bucket. The bucket then struck the injured employee, pinning him to the outrigger. The employee suffered crush injuries to the chest.

The injured employee was being trained on loading trucks in the load out bay. The injured employee and his supervisor climbed the stairs that run parallel to the truck and trailer, walked to the upper platform used for observation and sample taking, and saw that the lid of the grain trailer was closed. The employees began working to open the lid which appeared to be stuck due to cold weather. The injured employee pulled on one of the pivot arms that connect the lid to the main body of the trailer. As the lid began to open, the employee s right hand slipped down on the pivot arm and his index finger was caught between the pivot arm and the base of the pivot arm. The employee s right index finger was fractured and three nerves were severed. The employee was hospitalized.

On October 14, 2025, an employee was cutting lumber on an upcut saw. When he activated the saw to cut a short piece, the blade struck the tip of his right thumb, resulting in a partial amputation.

An employee was using a table saw to cut strips of plywood. The employee's left hand came into contact with the sawblade, which amputated the index and middle fingers as well as lacerating the hand. The employee was hospitalized, requiring surgery.

An employee was loading four sliding glass door panels into a truck. He was turning to get a cargo strap when the panels fell onto him and broke his neck.

An employee was using a table saw to cut a small bundle of vinyl material. The saw blade lacerated the employee's left index finger. The employee was hospitalized.

An employee had finished installing hurricane shutters on a customer's home and was putting his tools away and changing clothes. His hands began to cramp; he got out of his truck and collapsed on the road. He suffered an acute kidney injury and rhabdomyolysis caused by dehydration and heat illness.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.

An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.

A skid loader backed over an employee's leg, breaking it.

An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.