Allied Tube & Conduit Corporation

A temporary employee was assisting with the reinstallation of an exhaust hood on a mill zinc pot. As he was preparing to install bolts on the framework for the exhaust hood, he stepped on insulation that was covering an opening on the pot, submerging his right leg up to his knee into molten zinc and resulting in burns to the leg.

An employee was changing mud cups in the hopper cylinders of a concrete pump truck. The cylinders moved and three of the employees fingers were amputated.

An employee was standing on the rig floor next to a polishing unit. His hand was placed on the polishing unit when the pump was lowered, resulting in amputation of their right thumb, ring, and middle fingertips.

An employee was using air to blow out the air wash to the blender and grinder station. As the employee reached to verify that the air wash was clean, the unit pinched and amputated their fingertip.

An employee was retrieving a lost drill pipe with a lifting bail when their left thumb got pinched between the table and handle of the lifting bail while trying to re-thread the pipe to lift it out. The employee suffered an amputation to the left thumb.

An employee was removing a core chuck from a stationary roll when their right ring finger was pinched between the chuck and the roll. The employee's fingertip was amputated.

An employee was performing maintenance on the second level of a silo. While they were making sure the belt pulley were not seized up, the belt was powered on, causing the employee's finger to get caught in the sheave. Their left little finger was partially amputated.

An employee was operating a table saw to cut pieces of lumber measuring 2x2x36 inches. The blade contacted the employee's left thumb, cutting half of the distal phalange bone and amputating the thumb tip along the bottom of the fingernail.

A temporary employee was wrapping a chain around a 2,000-pound block of metal, located on the ground. The block tipped over and crushed his right foot. He was hospitalized, requiring surgery.

An employee was observing the clean-up process of a spilled ladle. As the employee was walking away from an area of cooling metal, there was an eruption due to molten metal reacting with water. The employee fell forward, attempted to catch himself, and his right hand touched the molten metal resulting in burns to the little fingertip and middle finger.

An employee was helping unload a skid steer off a truck skip. While positioned with his left foot on the skid steer's step and his right foot on the tire, he was helping unhook the chains from the truck skip and slipped and fell backward, landing on the rear rail of the truck skip. He suffered six broken ribs and a flail chest injury.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.