Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at GT USA Wilmington LLC, 1 Hausel Road, WILMINGTON, DELAWARE 19801
on — Amputations, affecting the fingertip(s).
Final narrative
An employee had just serviced a generator. The employee was removing a rag when the generator's fan blade cut off the tip of the employee's left index finger.
An employee was walking past vehicles lashed to a ship when she tripped on a lashing strap and fell to the deck. She suffered a hip fracture and was hospitalized.
An employee was on a container ship's catwalk, lashing containers to secure them. The employee fell to a deck about 15 feet below and suffered spine fractures, lacerations to the liver, and a head injury that required stitching. The employee was hospitalized.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee was conducting welding repairs inside a ballast water tank on a docked ship. The employee began to experience signs of heat exhaustion, resulting in hospitalization.
An employee was stacking steel pipes and securing loose pieces when a unit rolled from the stack and struck his lower right leg. He sustained a lower right leg fracture.
An employee was removing sheet metal from a flat roof. He unhooked his personal fall arrest system (PFAS) to walk to a different location. He stepped on an unsupported end of the sheet metal and the sheet metal folded, causing the employee to fall approximately 15 feet to the cement floor. The employee sustained fractures to his wrist, hip, and femur.
An employee was removing bailing wire from the floor. As they bent down to pick up the wire, a strand of bailing wire that was sticking up from the floor went under his safety glasses and struck his eye.
A flagger was directing traffic flow in a highway work zone. They were standing approximately 1.5 feet behind the shoulder's demarcating line, next to and slightly behind a traffic drum. As they were directing traffic into and out of the driveway of a parking lot, a car attempted to get around a truck and struck the traffic drum, which subsequently struck the employee, who was thrown 15 feet and landed on top of concrete aggregate. The employee suffered pelvic and rib fractures, T10 and L3 vertebra fractures, and internal bleeding.
An employee was troubleshooting a power washer in the field. Because there might have been water in its fuel, he brought it back to the shop and drained about a gallon of fuel from the tank into a plastic container. Some of the fuel spilled onto the floor and ignited. The employee was stomping out the fire when he lost his balance and tripped into a stool, which caused the plastic container to spill more fuel onto the fire. The employee's pants and shirt caught on fire, and he fell, abrading his knee while trying to get through the flames. As well as the knee abrasion, he suffered burns to the left leg and left lower quadrant of the torso. He was hospitalized.
An employee was backing up a tram (towing powered industrial equipment) to connect it to a trash bin. The employee's left forearm/wrist was caught and crushed between the tram and the bin. The employee was hospitalized.
An employee went to lift a carton and tripped on a different carton that was on the floor. She fell on the floor in the backroom and sustained a fractured right hip, and abrasions to her arm and knee. The employee was hospitalized and required surgery.