Delaware River Stevedores

An employee was using his left hand to push an axle down the line on a raised track work area while holding the remaining axle back with his right hand. A finger on his right hand was caught between the rail and the dust guard of the axle, resulting in a fracture and a laceration.

An employee was moving metal out of a cart. He had removed one piece and was working to move another when the metal shifted. His right ring finger was crushed between the two pieces, and he suffered a partial amputation to the finger pad at the tip.

A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.

Employees were replacing a 24" pig trap door. A strap was shackled on the pig trap door and connected to a forklift. Welders began to cut the door off. An employee was holding onto the door when the cut was finished. The door shifted and caught his fingers, resulting in a hand injury and amputation.

An employee used a crane to set down a bar. The bar measured 9 inches by 16 feet. The strap got stuck under the bar, and the employee asked another employee to jog the roll. The bar rolled and pinched the injured employee's left hand, resulting in a fingertip amputation.

An employee was conducting welding repairs inside a ballast water tank on a docked ship. The employee began to experience signs of heat exhaustion, resulting in hospitalization.

An employee was removing sheet metal from a flat roof. He unhooked his personal fall arrest system (PFAS) to walk to a different location. He stepped on an unsupported end of the sheet metal and the sheet metal folded, causing the employee to fall approximately 15 feet to the cement floor. The employee sustained fractures to his wrist, hip, and femur.

An employee was opening the door of a container. His finger got caught between the container doors, resulting in a fingertip amputation.

An employee was removing bailing wire from the floor. As they bent down to pick up the wire, a strand of bailing wire that was sticking up from the floor went under his safety glasses and struck his eye.

An employee was replacing a drive motor belt on a conveyor system across a walkway with an incomplete guardrail system. He was loosening the pulley bolt to create slack in the belt when he lost his balance and fell 25 feet to the ground. The employee sustained a cracked rib, a fractured pelvic bone, and a separated shoulder. He was hospitalized.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

An employee was inspecting a breaker box and turning on/off a circuit breaker when he was electrocuted.

An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.