Penmor Lithographers

An employee was going to the breakroom when they tripped over a chair and fell, resulting in a hip fracture.

An employee arrived at work and was walking into the store through the parking lot. The employee tripped over a curb and fell to the ground, sustaining a femur fracture.

An employee tripped over a box and fell to the floor, fracturing their right arm.

An employee tripped over a piece of angle iron and fell to the floor sustaining a broken hip.

An employee was preparing for a CT scan when she tripped over a loose strap and fell to the floor, fracturing her hip.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

The injured employee's standup forklift had mechanical issue with a tire. The injured employee was inside their forklift to help steer it while it was being pushed up the ramp by another forklift. As the other forklift started to move up the ramp, it's forks moved and went into the driver's space of the disabled forklift. The fork penetrated the injured employee's left shoe, fracturing the two middle toes and injuring the first toe. The employee was hospitalized and required surgery.

A press was having a paster failure and the crew was working to get the ink on the paper. A press operator grounded himself and was entering the press unit when something flashed. The employee sustained third-degree burns to his head and left arm.

Around 12:45 PM, a clamp truck operator went to remove a piece of orange strap from a clamp truck that was parked outside of the office. The strap fell into a gap between the frame and the hood of the truck. The strap became caught in the engine's fan and also wrapped around the employee's hand when he went to grab it. The strap was pulled tight against the frame of the clamp truck, causing lacerations and fractures to the employee's hand. The employee was hospitalized and required surgery.

At 12:00 p.m. on August 13, 2025, an employee was unloading a 1,100-pound roll of paper from a skid when the roll fell onto his right leg. The leg was broken.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.