STUTTGART, ARKANSAS—
Delta Plastics of The South LLC
Other fall to lower level less than 6 feet · Amputations
At a glance
Federal OSHA recorded a severe workplace injury at Delta Plastics of The South LLC, 3104 South Main St, STUTTGART, ARKANSAS 72160 on — Amputations, affecting the thigh(s).
Final narrative
An employee was unchoking a friction washer system. He climbed on the floater table, which is 50 inches from the ground, and placed the lid back on the friction washer. As he was climbing back down, he slipped and his left leg fell into the auger, resulting in the amputation of the left leg above the knee.
More severe injuries at Delta Plastics of The South LLC
STUTTGART, ARKANSAS—
DELTA PLASTICS OF THE SOUTH, LLC
An employee was checking the vacuum on a machine when he noticed that the water level was getting high in the slurry. He discovered that pellets were clumping together; when he tried to stir the water, he received an electrical shock caused by a wire that had shorted out. He suffered head and neck pain and was hospitalized.
STUTTGART, ARKANSAS—
Delta Plastics Of The South, LLC
Employees were preparing to adjust the blade on the grinder machine. Product was not completely clear from the grinder which prevented the carriage blade from rotating. An employee climbed up onto the carriage and used his weight to force the carriage blade to move. When it did, the employee stepped off the carriage and his left big and second toes were amputated by the blade.
STUTTGART, ARKANSAS—
Delta Plastics Of The South LLC
An employee was monitoring the production conveyor to remove defective products from production. While he was pulling a large piece of plastic off the conveyor, the piece of plastic fell into the equipment. The plastic started making a loud noise, so the employee attempted to remove it. His hand was then pulled into the equipment's wheel area. His right thumb and index finger had to be partially amputated. The guard was in place at the time.
STUTTGART, ARKANSAS—
DELTA PLASTICS OF THE SOUTH, LLC
An employee was about to load his truck when a coworker deployed an outrigger that hit the employee's foot.
View Delta Plastics of The South LLC's full OSHA safety record →
Similar incidents · Same event type
JACKSON, MISSOURI—
Electrical Contractors Inc.
An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.
FORT RUCKER, ALABAMA—
M1 Support Services
An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.
PHILADELPHIA, PENNSYLVANIA—
FEDEX Ground Package System, Inc.
An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.
LAFAYETTE, COLORADO—
SRM Concrete
An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.
LOS ANGELES, CALIFORNIA—
U.S. Postal Service - Los Angeles P&DC
An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.
More severe injuries in this industry (NAICS 326113)
WHARTON, TEXAS—
Nan Ya Plastics Corporation USA
A subcontracted engineer was advising maintenance how to make a modification to the embossing roll system on a new line. Maintenance was bringing the motor and gearbox down with a crane. The load shifted when it was a few inches from the ground. The engineer went to catch/maneuver the gearbox and the fingers on his left hand were crushed between the I-beam base of the gearbox and the concrete floor. A finger was amputated.
FLIPPIN, ARKANSAS—
Micro Plastics, Inc.
On July 30, 2025, an employee was assisting co-workers in using a hoist to position an injection molding tool onto a work table. As the tool was being lowered, the slide section shifted, trapping and amputating the employee's right thumb tip.
PALMER, MASSACHUSETTS—
Novacel, Inc.
An employee was manually lifting a film roll when their right middle fingertip was pinched between the roll and a metal beam, resulting in a fingertip amputation.
MENOMONIE, WISCONSIN—
3M Company
At about 10:00 a.m. on July 13, 2025, an employee was cleaning the adhesive from running rollers using a rag soaked in cleaning solvent to prevent contamination. The rag was caught between two rollers and pulled the employee's right hand between the rollers. The employee sustained right hand crushing injuries, de-gloving injuries (palmer and dorsal sides), and fractures. The employee was hospitalized and required surgery. The machine was not locked out/tagged out at the time.
ARCHBALD, PENNSYLVANIA—
Simona America Inc.
An employee working on a sheet line was removing masking from the underside of plastic sheeting that was being lifted by a vacuum lift. The plastic sheet measured 4 feet wide, 14 feet long, and approximately 1 inch thick, and it weighed approximately 300 pounds. The vacuum lost suction and dropped the plastic sheet onto the employee's arm, pinning it between two sheets and resulting in a broken right forearm.
More severe injuries in ARKANSAS
BLYTHEVILLE, ARKANSAS—
NATIONAL MILL MAINTENANCE, LLC
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
TEXARKANA, ARKANSAS—
The Goodyear Tire & Rubber Company
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
OSCEOLA, ARKANSAS—
Big River Steel, LLC
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
PINE BLUFF, ARKANSAS—
American Tile & Marble Co., Inc
An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.
SCRANTON, ARKANSAS—
Johnson Industrial Coatings, LLC.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.