Caught in running equipment or machinery during maintenance, cleaning · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Nolato Jabar LLC, 252 Brighton Road, ANDOVER, NEW JERSEY 07821
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was attempting to start an extruder. The extruder would not start, so the employee grabbed the belt to pull and rotate the motor with his right hand. Four of his right fingertips were then pulled by the belt into the pulleys, resulting in the amputation of the four fingers.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 326299)
An employee was guiding a conveyor belt through a slitter when their hand was caught between the rollers and the table. When the employee pulled their hand out, the glove was left behind and their right middle fingertip was amputated.
A maintenance employee was working to place a 120-pound metal screen on top of a machine before installation, with the help of another employee. The injured employee's right ring finger was pinched between the screen and the machine and the fingertip was partially amputated.
On September 26, 2025, an employee was performing maintenance on an excavator when a bale of rubber fell from an adjacent rack and struck him. The employee sustained multiple fractures to his pelvic area.
An employee was cleaning a mixer door. The employee's left hand came into contact with the mixer blade, which was still slowly rotating. The employee suffered amputations to the left index and middle fingertips.
A temporary employee was working to remove a detached piece of rubber EPDM product that was hanging on the outside of a feed chute. As the employee grabbed the elongated material, the material reengaged inside the machine above the feed chute and pulled back, pinching their left index fingertip. The employee's fingertip was amputated.
An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.
An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.
An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.