ICM Biofuels

An employee connected a steam line to a hose to clean equipment when the fitting broke loose. They were struck by steam in the left inner thigh, resulting in burns that required hospitalization.

An employee was straining hot water from a pot of rice when the water splashed onto them, resulting in burns to their chest, arms, shoulder, and back.

An employee was making tea when she noticed tea grinds were collecting on the side and water was no longer dripping through the funnel. The employee was checking the funnel when boiling water and tea grinds spilled onto the left side of her body. The employee sustained burns to her neck, back, and arm.

An employee had turned off the ball valve on a waterpipe system and was removing the plug when the coupling system attached to the strainer came apart. Hot water sprayed on his arm and back, resulting in first- and second-degree burns that required surgery.

An employee was using a shovel to remove waste vermiculite from molten zinc. The metal had been placed in a bin and partially hardened. The employee broke through the partially hardened metal; still-molten metal flowed to the employee's steel-toed right boot and entered through the cloth boot tongue. The employee suffered a third-degree burn to the right foot and was hospitalized.

An employee was backing up a forklift when the frame of the forklift clipped the wall. The employee's right little finger was pinched between the wall and the forklift, resulting in amputation.

An employee was removing contaminants from a low point drain on an ammonia line through a hose and into a container of water. A release of pressure from the end of the hose exposed the employee to anhydrous ammonia, resulting in chemical burns to his face, arm, and chest as well as ammonia inhalation. He was hospitalized.

An employee was priming a cook pump and sustained burns from contact with hot water (140-200 degrees F).

At about 7:00 a.m. on February 11, 2025, an employee was troubleshooting a system that had failed to start. Suspecting a tripped breaker and intending to test the system's motor leads, he hooked up an insulation resistance tester. The side of the breaker the tester was hooked up to was still energized, resulting in an arc flash. The employee was hospitalized with second-degree burns to his face and right arm.

An employee was preparing hopper rail cars for loading. The employee fell from the platform used to access the rail car lids, landing in an empty hopper and suffering broken ribs.

An employee was readjusting a safety hook to remove hardware from gang forms when his feet slipped. He fell to the ground, resulting in a broken left arm and wrist.

An employee was on a step ladder in a store aisle, making room on shelving for merchandise. She fell from the step ladder to the floor, suffering two fractures in her left leg. She was hospitalized, requiring surgery.

An employee was closing the side cargo door to a company van. The tip of his finger got caught between the door and the door jamb, resulting in a partial amputation.

An employee lost his footing while climbing an inclined ladder. He stumbled down one step and was able to stabilize himself by holding the railing and twisting his body, but he suffered an internal abdominal injury and was hospitalized.

An employee was manipulating dies on a brake press. The press caught and crushed the employee's right forearm, resulting in hospitalization.