Exposure to electric arc · Electrical burns any degree
At a glance
Federal OSHA recorded a severe workplace injury
at Big River Resources Galva, LLC, 1100 S.E. 2ND, GALVA, ILLINOIS 61434
on — Electrical burns any degree , affecting the Head and extremities.
Final narrative
At about 7:00 a.m. on February 11, 2025, an employee was troubleshooting a system that had failed to start. Suspecting a tripped breaker and intending to test the system's motor leads, he hooked up an insulation resistance tester. The side of the breaker the tester was hooked up to was still energized, resulting in an arc flash. The employee was hospitalized with second-degree burns to his face and right arm.
Hospitalized Head and extremities Switchboards, panels, fuses
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee was backing up a forklift when the frame of the forklift clipped the wall. The employee's right little finger was pinched between the wall and the forklift, resulting in amputation.
An employee was removing contaminants from a low point drain on an ammonia line through a hose and into a container of water. A release of pressure from the end of the hose exposed the employee to anhydrous ammonia, resulting in chemical burns to his face, arm, and chest as well as ammonia inhalation. He was hospitalized.
An employee was preparing hopper rail cars for loading. The employee fell from the platform used to access the rail car lids, landing in an empty hopper and suffering broken ribs.
An employee was changing eye bolts on a strainer when their right foot slipped on hot slurry mash, resulting in injuries to their right shin and upper ankle.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.