Tropical Shipping USA, LLC

An employee was conducting welding repairs inside a ballast water tank on a docked ship. The employee began to experience signs of heat exhaustion, resulting in hospitalization.

An employee was working from the ground, helping as a crane placed cargo loaded on flat racks onto a road chassis. As the employee moved to place a connecting pin, a flat rack shifted and crushed his right index finger. Half of the finger was amputated.

An employee had just unjammed a warehouse dock leveler. The end of the dock leveler came down on the employee's left middle and ring fingers, crushing them against a container and causing avulsions.

An employee was assisting in the loading of a 20' flatrack onto a vessel. The employee installed a lifting cable into position and applied tension to the cable using his right hand. As the cable pressed against the flatrack, the tip of the employee's right index finger was pinched off.

An employee was helping to lift a flatrack and had placed his hand on the cable to keep the tension when the tension cable amputated his right ring fingertip.

A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.

An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.

The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.

An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.

An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.

An employee was conducting welding repairs inside a ballast water tank on a docked ship. The employee began to experience signs of heat exhaustion, resulting in hospitalization.

An employee was stacking steel pipes and securing loose pieces when a unit rolled from the stack and struck his lower right leg. He sustained a lower right leg fracture.

An employee was removing sheet metal from a flat roof. He unhooked his personal fall arrest system (PFAS) to walk to a different location. He stepped on an unsupported end of the sheet metal and the sheet metal folded, causing the employee to fall approximately 15 feet to the cement floor. The employee sustained fractures to his wrist, hip, and femur.

An employee was opening the door of a container. His finger got caught between the container doors, resulting in a fingertip amputation.

An employee was removing bailing wire from the floor. As they bent down to pick up the wire, a strand of bailing wire that was sticking up from the floor went under his safety glasses and struck his eye.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.