Caught in running equipment or machinery during regular operation · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at H & R Scrap Metal Company Inc., 900 W. Fond Du Lac Avenue, MILWAUKEE, WISCONSIN 53225
on — Fractures, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was using a wire stripping machine. The machine caught his glove and pulled in his hand. He suffered lacerations to his index and middle fingers and his thumb (which was split down the middle), as well as a broken bone.
HospitalizedFinger(s), fingernail(s), unspecifiedMetal, woodworking, and special material machinery, n.e.c.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333999)
An employee was working on an assembly line in the production facility. He was on the south part of the aisle, checking for debris in the system, and went to remove a screw. His left foot became caught in a wheel on a track along the assembly line. All of the toes on his left foot were amputated.
A maintenance employee was using an air wand to clean equipment. The air wand became caught in the rollers that were turning and the employee's left arm was pulled into the equipment. Their arm was crushed to the elbow and the fifth digit on their left hand was amputated.
On July 3, 2024, at approximately 8:00 AM, an employee was installing a pulling sheave in an electrical gear when they received a high-voltage electrical shock and sustained arc flash burns.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.