Exposure to electric arc · Electrical burns and electrocution
At a glance
Federal OSHA recorded a severe workplace injury
at Johnson Controls Inc, 999 E 37th Street North, WICHITA, KANSAS 67219
on — Electrical burns and electrocution, affecting the Body systems and other part(s) of body.
Final narrative
On July 3, 2024, at approximately 8:00 AM, an employee was installing a pulling sheave in an electrical gear when they received a high-voltage electrical shock and sustained arc flash burns.
Hospitalized Body systems and other part(s) of body Switchboards, panels, fuses
An employee was manually adjusting a wooden pallet when he lost his balance and fell to the floor. The pallet fell on the employee's abdomen and they were hospitalized with internal bleeding.
An employee was removing a part from a brake press when the machine's backstop came back and caught the employee's finger against the bottom die. The employee's fingertip was crushed and degloved, and the employee was hospitalized.
An employee was installing a base pan to the rails on a lift table. The conveyor was lowered to the home position and the employee's left foot was pinned underneath the table, resulting in a fracture.
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee was working on an assembly line in the production facility. He was on the south part of the aisle, checking for debris in the system, and went to remove a screw. His left foot became caught in a wheel on a track along the assembly line. All of the toes on his left foot were amputated.
A maintenance employee was using an air wand to clean equipment. The air wand became caught in the rollers that were turning and the employee's left arm was pulled into the equipment. Their arm was crushed to the elbow and the fifth digit on their left hand was amputated.
An employee was cutting a brass punch on the band saw. When the employee went to clamp the brass part, the part moved causing the clamp to crush the end of their right middle finger and it amputated the finger between the first knuckle and the fingernail.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.