CHANUTE, KANSAS—
River Rock Operating LLC
Contact with hot objects or substances · Third or fourth degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury at River Rock Operating LLC, Fireside Compression Yard, CHANUTE, KANSAS 66720 on — Third or fourth degree heat (thermal) burns, affecting the head, neck, and trunk.
Watch River Rock Operating LLC — free
Get an email when a new federal OSHA severe-injury report for River Rock Operating LLC is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was conducting maintenance on a natural gas glycol dehydration unit when the housing unit ruptured and hot glycol fluid made contact with the employee, leading to hospitalization for third degree burns on top of the head, neck, and back.
More severe injuries at River Rock Operating LLC
COFFEYVILLE, KANSAS—
River Rock Operating, LLC
An employee was doing maintenance on a gas well pump jack. The brake did not hold when he set it, and a belt and pulley caught his hand. He suffered an amputation to the little finger, about 7/8 of the way from the end.
CHANUTE, KANSAS—
River Rock Operating, LLC
An employee was attempting to change a gear belt on a motor that had seized on a pumping unit when the belt started moving and caught his thumb, lacerating and breaking it. The motor was not locked/tagged out at the time of the incident.
View River Rock Operating LLC's full OSHA safety record →
Similar incidents · Same event type
BAY CITY, TEXAS—
OQ Chemicals
An employee connected a steam line to a hose to clean equipment when the fitting broke loose. They were struck by steam in the left inner thigh, resulting in burns that required hospitalization.
HAUPPAUGE, NEW YORK—
Husbe Zoaq
An employee was straining hot water from a pot of rice when the water splashed onto them, resulting in burns to their chest, arms, shoulder, and back.
FORT WORTH, TEXAS—
The Cumberland Rest Inc. dba Trinity Terrace
An employee was making tea when she noticed tea grinds were collecting on the side and water was no longer dripping through the funnel. The employee was checking the funnel when boiling water and tea grinds spilled onto the left side of her body. The employee sustained burns to her neck, back, and arm.
SAN ANTONIO, TEXAS—
Mueller & Wilson Inc
An employee had turned off the ball valve on a waterpipe system and was removing the plug when the coupling system attached to the strainer came apart. Hot water sprayed on his arm and back, resulting in first- and second-degree burns that required surgery.
MADILL, OKLAHOMA—
Oklahoma Steel & Wire Co., LLC
An employee was using a shovel to remove waste vermiculite from molten zinc. The metal had been placed in a bin and partially hardened. The employee broke through the partially hardened metal; still-molten metal flowed to the employee's steel-toed right boot and entered through the cloth boot tongue. The employee suffered a third-degree burn to the right foot and was hospitalized.
More severe injuries in this industry (NAICS 213111)
HANNIBAL, OHIO—
Hall Drilling, LLC
An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.
PILOT POINT, TEXAS—
C. Miller Drilling Inc
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
WATFORD CITY, NORTH DAKOTA—
Amercian Well Service Llp
An employee was working to remove a stuck fish tool from a drill shoe. Their thumb was struck by a hammer, resulting in amputation.
WICKETT, TEXAS—
Axis Energy Services
An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.
PECOS, TEXAS—
ROBINSON DRILLING OF TEXAS, LTD
An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.
More severe injuries in KANSAS
WATHENA, KANSAS—
Omya Inc.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
COFFEYVILLE, KANSAS—
John Deere Coffeyville Works
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
HAVEN, KANSAS—
Haven Steel Products Inc
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
MINNEOLA, KANSAS—
Vestas-American Wind Tech
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
MEADE, KANSAS—
Alliance Ag and Grain LLC
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.