BLYTHEVILLE, ARKANSAS—
JMS Russel Metals Corp.
Standing, standing up-single episode · Fractures
At a glance
Federal OSHA recorded a severe workplace injury at JMS Russel Metals Corp., 5027 No. County Rd. 1015, BLYTHEVILLE, ARKANSAS 72315 on — Fractures, affecting the thigh(s).
Final narrative
An employee was in a parked golf cart. He placed his feet on the ground beside the golf cart and grabbed the side of the cart to prepare his body to stand. As he stood up, he felt a pop in his right leg and fell over onto the ground. He was hospitalized with a broken femur in his right leg. His leg had a weakened bone due to a prosthetic from a previous amputation he had suffered.
More severe injuries at JMS Russel Metals Corp.
BLYTHEVILLE, ARKANSAS—
JMS Russel Metals Corp.
An employee was setting up a splitter table. Upon reaching to help the table rotate, the employee's gloved hand got caught between a switch and a metal plate, resulting in an amputation of the left index fingertip.
BLYTHEVILLE, ARKANSAS—
JMS Russel Metals Corp.
An employee was working on a slitter machine when the rubbers on its arbor caught his right hand and pulled his arm through the slitter head. The employee's right hand and arm were crushed.
BLYTHEVILLE, ARKANSAS—
JMS Russel Metals Corp.
An employee had been sitting idle in an air conditioned 18-wheeler and then came into the office with symptoms of lightheadedness, dizziness, and slightly elevated blood pressure. The employee was hospitalized due to heat stress (dehydration, heat exhaustion).
BLYTHEVILLE, ARKANSAS—
JMS Russel Metals Corp.
An employee was wrapping a coil of steel with an ID band at an exit turnstile and slitter cart. His right leg was over the rail between the cart and the end stop when the cart moved and pinned his right leg, breaking it.
BLYTHEVILLE, ARKANSAS—
JMS RUSSEL METALS CORP.
An employee was leaning against a guard that rotates a product conveyor when his glove became caught in a gap on the conveyor and began rotating. As he pulled his hand out of the glove, his left ring fingertip and nail were amputated.
View JMS Russel Metals Corp.'s full OSHA safety record →
Similar incidents · Same event type
BRIDGEVIEW, ILLINOIS—
The Wendy's Company
A Wendy's employee was conducting dishwashing procedures at a dedicated dishwashing sink in the kitchen area. The employee heard an audible "pop" from their hip region and experienced hip pain. The employee was hospitalized with a femoral neck fracture.
PITTSBURGH, PENNSYLVANIA—
Oxford Development Company
An employee suffered a back injury while getting up from his desk chair.
HOLYOKE, MASSACHUSETTS—
Trulieve Holyoke Holdings LLC
After bending over to pick up a computer mouse, an employee straightened up and felt severe back pain. He was hospitalized.
MOONACHIE, NEW JERSEY—
Deciem USA LLC
An employee was bent forward at the waist placing boxes inside a gaylord container and adjusting the positioning of the boxes to organize them better. The employee stood up and felt pain in the lower back.
PHOENIXVILLE, PENNSYLVANIA—
U.S. Home Corporation
An employee was removing debris from the ground when they stood up and sustained a hernia.
More severe injuries in this industry (NAICS 331110)
LEVITTOWN, PENNSYLVANIA—
Floworks International LLC
An employee fell while entering the building. The employee was hospitalized with a fractured ankle and required surgery.
OSCEOLA, ARKANSAS—
Big River Steel, LLC
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
PEORIA, ILLINOIS—
Keystone Consolidated Industries, Inc.
An employee was working to close a furnace door. The hydraulic mechanism that opens and closes the furnace door was non-operational and had been disconnected to allow the furnace door to be opened manually. As the employee was releasing the pins that held the door open, the door and the hydraulic cylinder fell, pinching their left hand between the hydraulic cylinder's base plate and the furnace. The employee suffered amputation of the little fingertip.
SEGUIN, TEXAS—
Commercial Metals Company
A rolling mill was shut down due to a cobble between two mill stands. The injured employee was cleaning the cobble from the delivery side of stand A, while another employee went to the control panel to move stand B and stand A moved instead. The injured employee's right thumb got caught between the delivery guide of stand A and the looper trough. The tip of his thumb required surgical amputation to the bone to allow for stitches.
BEAVER DAM, WISCONSIN—
Metalcraft of Mayville, Inc.
An employee was helping another employee load stock material onto a press brake when the stock slipped. The injured employee's right index finger was caught between the press brake die and the stock, resulting in amputation at the first knuckle.
More severe injuries in ARKANSAS
BLYTHEVILLE, ARKANSAS—
NATIONAL MILL MAINTENANCE, LLC
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
TEXARKANA, ARKANSAS—
The Goodyear Tire & Rubber Company
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
OSCEOLA, ARKANSAS—
Big River Steel, LLC
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
PINE BLUFF, ARKANSAS—
American Tile & Marble Co., Inc
An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.
SCRANTON, ARKANSAS—
Johnson Industrial Coatings, LLC.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.