Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Rogers Foam Corporation, 20 Vernon St., SOMERVILLE, MASSACHUSETTS 02145
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was operating a foam profile machine. As the employee attempted to remove a piece of foam from within the profile machine their finger contacted the blade resulting in a partial amputation.
AmputationFinger(s), fingernail(s), unspecifiedMetal, woodworking, and special material machinery, n.e.c.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 326140)
An employee was performing a maintenance task on a shape mold machine. The equipment had a clog preventing it from pumping material into the next stage. The employee's left hand was inside the hopper's butterfly valve when it unexpectedly turned. The employee's index and middle fingertips were partially amputated.
An employee was stacking used cardboard onto a pallet in the shipping and receiving area when he tripped over the scale by the loading dock door. The employee fell to the concrete floor and was hospitalized with a fractured left hip that required surgery.
On May 14, 2025, an employee was manually adjusting a plastic sheet entering the thermoforming oven when their right hand was pulled into the pin chain and idler wheel. The employee sustained the amputation of their middle finger.
At 6:30 p.m. on April 23, 2025, an employee was using a CNC panel saw when his fingers were pinned in by the pressure beam used to hold the board he was cutting. The sawblade, coming from beneath, amputated about 1/4 inch of his right little fingertip.
An employee was diagnosing an issue with a bagger that had jammed. The employee was cleaning out a piece of supporting equipment (a scrap barrel) when the blower motor contacted his right middle fingertip and fingernail, resulting in an amputation. The blower motor was not guarded at the time.
An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.
Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.
An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.