Other fall to lower level 11 to 15 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Mancini Sheet Metal Inc, 41 Mall Road, BURLINGTON, MASSACHUSETTS 01803
on — Fractures, affecting the ankle(s).
Final narrative
An employee was installing ventilation grating. The employee slipped and fell 15 feet to the ground below resulting in hospitalization for a fractured ankle.
The employee was on top of a rail car to level the grain that was deposited into the car when they fell 13-15 feet to the ground. The employee sustained a right leg fracture.
An employee was on an extension ladder installing a satellite dish on a roof when they fell approximately 12-15 feet to the ground. The employee sustained fractures.
An employee was setting a 5-foot pry bar into a precast concrete slab and stood on the end of the pry bar to move the slab into place. The pry bar slipped out causing the employee to fall backward 15.5 feet to the dirt ground. The employee was hospitalized with a broken leg.
An employee was on a step ladder to measure and mark a crane rail for modification. The employee fell approximately 12 to 15 feet to the ground, resulting in a fractured right hip.
An employee was on a trailer securing a load of logs when they fell approximately 9-12 feet to the ground. The employee sustained brain hemorrhaging and lacerations to the thigh and above the eye. The employee was hospitalized.
More severe injuries in this industry (NAICS 238390)
An employee was using a 10-foot step ladder to install roller shades. The employee fell from the third rung from the top, landing on the ground and suffering back and head injuries. The employee was hospitalized.
While on a scaffold, an employee was transporting heated sealant material in a bucket. The employee tripped and fell, causing the heated material to splash onto his gloved hands. The employee sustained second-degree burns to both hands and his right wrist.
Three employees were pulling tension cable (similar to rebar) through the walls of a condo using a motor system. Two employees were needed to hold the cable while the third employee drilled the mounting locations. When the third employee activated the drill, the cables twisted. They caught the right index finger of one of the other two employees, amputating his fingertip.
An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.
Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.
An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.