Wisconsin Aluminum Foundry Co., Inc.

An employee was lifting a cope mold using a mold manipulator. While the mold was suspended in the air, he reached under it to retrieve the rollover pin. The mold slipped out of the manipulator and fell onto his right hand, causing a severe degloving of the right forearm and hand. He was hospitalized.

At 11:49 p.m. on July 11, 2024, an employee was sanding/grinding a circular aluminum casting on a belt sander/grinder. The casting slipped, and the employee's left thumb came in contact with the edge of the belt. The employee suffered a partial amputation to the thumb.

An employee was helping a dross bin, which was being raised by a forklift. The lever to empty the dross bin was pulled, causing the bin to tip forward and up. The employee's left index finger was caught between the forklift forks and the bin, and the fingertip was amputated.

An employee was using a knockout machine to finish aluminum castings. The machine was mounted in an A-frame. When the machine actuated, the employee's right middle fingertip was pinched and amputated between the hammer and the casting.

An employee was helping operate a hydraulic mold press. The press engaged, crushing the employee's left index fingertip. The employee suffered an amputation to the finger.

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

An employee suffered a partial finger amputation while troubleshooting equipment.

An employee was finishing the prep work on a mold in a low-pressure tilt machine. The machine started up and cycled, causing amputation and crushing injuries to the employee's fingers and hand.

An employee was performing maintenance on a pneumatic lathe when he sustained an amputation to the ends of three fingers.

An employee was using a pry bar to open a customer's tote. The tote gave way causing the employee to fall on the ground and land on his side. The employee was hospitalized with a broken left femur.

An employee was helping operate a hydraulic mold press. The press engaged, crushing the employee's left index fingertip. The employee suffered an amputation to the finger.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.