Caught in running equipment or machinery during regular operation · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at Morin Corporation, 861 Southeast St, BENTONVILLE, ARKANSAS 72712
on — Cuts, lacerations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was operating an uncoiler machine. He was inspecting the insert of the uncoiler when it caught his glove, pulling in his left hand. It sliced the thumb, causing an injury that required ten stitches and the insertion of a pin between the first and last joint.
HospitalizedFinger(s), fingernail(s), unspecifiedMaterial and personnel handling machinery, n.e.c.
A temporary employee was operating a power folder when the equipment was activated via the foot pedal. Two of the employee's fingers were then caught under the clamp, crushing the fingertips and resulting in a fingertip amputation.
On July 24, 2015, an employee was adjusting a roll-forming machine when his hand was pulled into the running die. He broke his left thumb and sustained a left index fingertip amputation.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332311)
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
Two maintenance employees were dismantling a machine part (steel cylindrical rollers) on the ground. After unbolting a portion, part of the assembly fell approximately 6 inches onto one employee's left little finger. The employee was hospitalized and about 3/4" of their little finger above the top joint was surgically amputated.
An employee was moving and handling cardboard boxes when he sustained a laceration to his left ring finger from a box. The laceration became infected and required hospitalization and surgery.
An employee was positioning a piece of metal trim for a test bend in a single-fold bend machine. Their right middle fingertip was pinched by a clamp on the machine, resulting in a partial amputation.
An employee was operating a double folding machine and positioning a piece of metal trim in the folding clamps for a test bend. The machine activated and the crank (lower control arm that bends the trim) came up and cut through the employee s glove, amputating their right middle fingertip.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.