Morin Corporation

An employee was operating an uncoiler machine. He was inspecting the insert of the uncoiler when it caught his glove, pulling in his left hand. It sliced the thumb, causing an injury that required ten stitches and the insertion of a pin between the first and last joint.

A temporary employee was operating a power folder when the equipment was activated via the foot pedal. Two of the employee's fingers were then caught under the clamp, crushing the fingertips and resulting in a fingertip amputation.

On July 24, 2015, an employee was adjusting a roll-forming machine when his hand was pulled into the running die. He broke his left thumb and sustained a left index fingertip amputation.

An employee was installing wood trim surrounding a skylight inside a home. While holding a piece of trim in it's desired location, his pneumatic nail gun discharged, sending a 3/4-inch pin nail into his left forearm.

An employee removed a safety valve on a trailer that unknowingly contained nitrogen gas. The gas released from the trailer and pushed the employee backward off a scaffold approximately 10 feet before they struck a garage door, resulting in a pelvic injury.

An employee was sitting at her workstation when a nail gun malfunctioned and shot a nail into her left leg. She suffered a puncture and blood vessel injury and was hospitalized.

On November 25, 2023, an employee was using a high-pressured water hose to perform sewer line cleaning operations. The employee's right little finger and palm were lacerated by pressurized water from the hose.

An employee was hydroblasting when they slipped and the pressurized water stream lacerated their left ankle.

Employees were at the trucks to leave for lunch. The injured employee was putting the cone back after the crew leader pulled the truck forward from the designated worker parking area. The injured employee then ran back to the truck. As he went to get in the truck, he said the upper thigh area of his leg was hurting. He laid on the ground outside the truck and crew leader could see a bump/bulge in the the injured employee's upper thigh area below his hip. The employee sustained a fractured femur and required surgery.

An employee was helping a contractor unload a delivery of two new dock plates from a trailer onto a forklift. The employee s left index and middle fingers were pinched by the dock plates, resulting in amputations to both fingers above the first joint.

An employee was helping to load a customer's truck. The employee stepped toward a forklift to get paperwork from the driver. The employee's right lower leg and foot were run over by the back tire of the forklift. The employee was hospitalized with fractures to his lower right leg.

An employee was moving wet bundles of shingles on a truck bed, when one of the bundles slipped out of his hands. He tripped over a pallet, fell off the bed of the truck, and landed on his left side. The employee sustained fractures to three ribs, and a displaced iliac fracture.

On August 12, 2025, an employee was loading shingles onto the roof of a new-construction home when be began to suffer from heat exhaustion and dehydration.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.