Pedestrian struck by vehicle in nonroadway area, unspecified · Internal injuries to organs and blood vessels of the trunk
At a glance
Federal OSHA recorded a severe workplace injury
at Premier Aluminum, LLC, 3633 South Memorial Drive, RACINE, WISCONSIN 53403
on — Internal injuries to organs and blood vessels of the trunk, affecting the abdomen, except internal location of diseases or disorders.
Final narrative
The injured employee was helping a forklift operator weigh and load scrap aluminum into a shipping container. The employee was caught between the forklift's hopper and a shelf mounted to a cinderblock wall and hospitalized for a broken pelvis and a lacerated spleen, colon and liver.
HospitalizedAbdomen, except internal location of diseases or disordersForklift, order picker, platform truck-powered
An employee was using a drill press to drill holes into a part. The employee was wearing gloves and the left glove got caught on the drill bit. The rotating drill bit pulled the employee's fingers into the drill causing an amputation of the left ring fingertip.
An employee was staging a part on a coordinate measuring machine. The employee put the part onto the fixture. A hole in the casting into which the fixture pin is placed was not big enough. The employee placed the part on its side to deburr the hole out. The employee was repositioning the part onto the fixture when it slipped and crushed his finger between the part and the fixture, amputating his fingertip. The part weighed about 56 pounds.
The employee was pouring metal (aluminum) from one ladle into another ladle that had been freshly coated with mold paint. When the molten metal hit the wet paint it "popped" and splashed molten metal onto the employee burning the employee's face, arms and body.
An employee was walking back to her workstation. A forklift reversed a short distance, then completed a U-turn and struck her, running over her lower extremities. She was hospitalized with a broken ankle.
An employee was training on a jockey truck. Upon stepping out of the truck, the employee was struck by a rubber tire gantry crane, resulting in amputations of the right leg above the knee and left leg below the knee.
An employee was standing at the rear of a double pallet jack. Another double jack approached, and the employee's lower leg was caught between the two pieces of equipment. He suffered a broken tibia and fibula.
An employee was unloading large material bags on a loading dock. A forklift tine pinned the employee's foot against a pallet, causing the employee to fall and suffer a broken ankle.
An employee was trimming manufactured parts using a two-hand control, C-frame trim press. They were manipulating parts in the machine when their hand contacted the controls that energized the machine. The employee sustained amputations to their left index finger and left thumb.
Two employees were operating an aluminum die casting machine when a piston that pushed molten aluminum into the mold stopped dispensing aluminum correctly. After they had spent several hours fixing the issue, the machine cycled and the die closed on one employee's right hand. The employee suffered amputations to the index fingertip and the thumb at the knuckle.
An employee was operating a mold machine when a pouring ladle that was coated with a water-based paste was submerged in molten aluminum. The moisture caused an explosion, resulting in severe burns over his body.
On September 10, 2024, at approximately 5:55 AM, an employee suffered burns to his right hand as he was removing a ladle from a furnace and the cup made contact with the side of the furnace, splashing molten aluminum into his glove. The employee was hospitalized with burns to his right hand.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.