Prime-Line Inc.

Employees were assembling and testing a butterfly valve unit and actuator combo. When the unit was function tested with air, the valve gate closed on an employee's left thumb resulting in a fracture and laceration.

An employee was doing a daily inspection of the sifter screen on a mixer when the mixer line activated. The armature for the screen struck the employee's right wrist. Their wrist was cut and their hand was fractured.

An employee was being trained on a machine when a roller came down on their hand, resulting in a fracture and laceration.

An employee was doing a dry run during the setup of an ice cream machine. The machine indexed and the filler head amputated the employee's left middle finger above the last knuckle.

An employee was on a 3-foot ladder guiding cable onto a spool during installation on an overhead door. As the control box was jogged, the employee's hand was caught between the cable and spool, resulting in a wrist and hand fracture.

Two employees were investigating smoke originating from a screw at the base of a dry fuel silo. While they were in the ground-level hopper area, a dust explosion occurred. Both employees were burned. One suffered burns to both arms, the face, and the left side of the torso; the other was burned on the face and chest, as well as suffering circumferential burns to the arms.

At 8:00 a.m. on April 22, 2025, an employee was responding to a tracking fault on the bottom head of a six-head sander. While he was straightening the belt, his right hand was pulled in, wedged, and lacerated. He was hospitalized.

An employee slipped and fell while sanding a plenum. The employee landed on their leg and was hospitalized with a broken tibia.

On January 20, 2025, an employee was walking between buildings when they slipped on ice and fell. The employee was hospitalized with fractures to their left tibia and fibula.

An employee was swapping motor leads to change the rotation on a river well pump motor when an arc flash occurred. The employee sustained second-degree burns to their hands and forearms.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.