Fall through surface or existing opening less than 6 feet · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Albemarle Corporation, 2270 Highway 79 S, MAGNOLIA, ARKANSAS 71753
on — Heat (thermal) burns, unspecified, affecting the ankle(s) and leg(s), n.e.c..
Final narrative
An employee was making his rounds and checking equipment when the wet ground underneath him gave way. He fell in a hole that was about 1.5 feet deep and contained hot water and steam condensate. The employee was hospitalized with burns to both lower legs and ankles.
HospitalizedAnkle(s) and leg(s), n.e.c.Ground, n.e.c.
On November 17, 2023, a maintenance employee opened a line and residual bromine was released. The employee sustained burns to their palm and left leg and also suffered an inhalation injury.
An employee was sliding a mechanical seal/sleeve onto a shaft. The shaft has a small groove with sharp edges. The employee's hand was on the shaft with his finger in the groove. When the employee slid the mechanical seal/sleeve on the groove, it amputated his right index fingertip.
An employee and two coworkers were working on a malfunctioning vacuum pump when the pump ruptured and sprayed the employee with hot lubricant, requiring hospitalization.
A temporary employee walked across a wooden pallet to retrieve product to stock. When he walked back across the pallet, it broke, causing the employee to fall to the ground and sustain a fractured hip.
On April 10, 2023, at 12:00 PM, an employee was using a broom to clear rock from a building's foundation in preparation for a spray-on vapor barrier. There was a 4-foot deep trench next to the building where the employee was working and the soil at the trench's edge fell away. The employee fell into the trench and was hospitalized for a left pelvis and/or femur fracture.
An employee was walking up a steel staircase to check wiring in the electrical room. The staircase had a top platform with a grate that was sitting across the beams of the platform. The grate had shifted and as the employee stepped on it, it gave way, causing him to fall approximately 3 feet to the ground below. The grate landed on the employee and he was hospitalized for four transverse process fractures in the lower spine.
An employee was stocking the freezer and stepped on a wood pallet. The employee's foot went into the pallet and they sustained a right ankle fracture that required hospitalization and surgery.
More severe injuries in this industry (NAICS 213111)
An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.
An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.