Wisconsin Electric Power Company

An employee was using a pneumatic torque wrench to rotate a bearing bolt on a bucket truck when the wrench slipped and the employee's finger was caught between the lever and a steel pedestal, resulting in a fingertip amputation.

On September 1, 2017, an employee was standing and waiting for a silo to empty when a piece of angle iron fell from above and struck the employee's hand, amputating the thumb tip.

An employee was removing a tree from a downed power line. The tree struck the employee in the head causing a skull fracture.

An employee was sweeping behind a guardrail and stepped on the lower portion of the guardrail when he lost his balance. As he stepped back, his foot became stuck between the guardrail and a transformer, resulting in a compound fracture of left tibia and fibula.

An employee was repositioning a chill adder so that the pig tubs behind it could be removed. The employee lost their balance and their finger was pinched between the chill adder and the pig tub, resulting in a fingertip amputation.

An employee was backing up a stand-up forklift. The vehicle struck a guard and a wooden table. Upon exiting the forklift, the employee's left leg became caught between the table and dock guard, causing a fractured leg.

An employee was working on a shoring scaffold with another employee to strip plywood from cement. The employees threw a 4x4 piece of forming down and it got stuck on the beam of the scaffold. The injured employee went to grab the forming when their left ring fingertip was pinched between it and the beam, resulting in a partial amputation.

An employee was using a torch to trim the foundation for a compressed air tank so the tank would fit in place. His left hand was caught between the tank and the steel bar foundation structure; the hand was crushed and burned.

Employees were pulling three-phase power lines to a power pole. An employee's hand was caught between a pulley and a rope, resulting in amputation of the employee's index, middle, and ring fingertips.

An employee was cutting through two secondary wires with a battery-powered cutting tool. The wires were energized at 120/240 volts; when the employee cut through the insulation around a wire, an arc flash burned the employee's left thumb.

An employee had been preparing material for a lineman at a jobsite and was pulling up wire on a hand line. The employee began to feel ill, suffering from heat illness.

An employee's right hand was broken after being struck by an excavator that was being moved.

An employee was tamping at the base of a power pole when they were struck by an extendable hot arm that was dropped from an aerial bucket. The employee sustained two broken ribs on the right side, and a pneumothorax on the right side.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.