Research Products Corporation

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

An employee was using a multimeter to ensure proper power supply to a newly repaired rotary screw air compressor before running a voltage test. An electrical arc flash occurred, resulting in burns to both the employee's hands and their face.

An employee was on the roof of a building, putting plastic around a dust collector, when their left middle finger was caught in a grinder insider the dust collector. The employee suffered a partial amputation to the left middle finger.

On August 4, 2025, an employee was fixing a jammed carousel and using a hook to manually adjust the carousel by hand. The hook slipped off and the employee fell to the concrete ground, resulting in hospitalization for a fractured right hip.

An employee was replacing a screen on a rooftop HVAC unit when the rotating exhaust fan blade contacted their right index finger, resulting in a laceration that required hospitalization and the surgical amputation at the first knuckle.

An employee was changing an air filter when the door to the HVAC closed due to wind. The employee sustained an amputation to the left thumb at the nailbed.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.