Struck by swinging or slipping object, other than handheld, n.e.c. · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Daybrook Fisheries, Inc., 136 Daybrook Lane, EMPIRE, LOUISIANA 70050
on — Soreness, pain, hurt-nonspecified injury, affecting the multiple body parts, n.e.c..
Final narrative
Two employees were attempting to remove a metal box from the outside of a building. On employee cut the top two bolts holding the box to the building, so that the bottom two box could act as a fulcrum as the box fell. The other employee was walking the box down, hand over hand, when it fell. Its top left corner struck him in the head, neck, and right shoulder, and he was briefly pinned under the box. He was hospitalized.
HospitalizedMultiple body parts, n.e.c.Boxes, crates, cartons
On October 26, 2020, an employee was using a ladder to clear fishmeal from the cyclone funnel meal feeder on an elevated conveyor. While walking on the conveyor, the employee stepped onto a breaker box that was mounted on a pole alongside the conveyor. The breaker box broke free from it's metal mounting bracket, and the employee fell approximately 5'6" to the floor. The employee's right arm was lacerated by a mounting bracket as he fell. The employee was hospitalized for surgery to close the wound.
An employee turned on a process pump inside a fish processing plant. The pump cap housing blew off causing hot water to forcibly flow out of the pump and strike the employee in multiple areas on the front of his body. As the employee turned away from the hot water, he was struck in multiple areas on the back of his body and knocked to the ground momentarily. Hot water also struck a second employee on the back while running away from the area.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 311712)
On July 7, 2025, an employee was cleaning food from under a conveyor belt. He was retrieving a piece of food when his left middle finger contacted the chain and pulley. The fingertip was amputated. The machine was guarded at the time of the incident.
On December 16, 2024, at approximately 3:07 p.m., an employee was feeding frozen fish blocks via a conveyor belt into a floor mounted electrically powered grinder. The grinder became jammed with the fish material. The worker deenergized the machine and used a rolling ladder to climb approximately 4 feet in the air to unjam it. As the fish block became dislodged, the momentum of the action caused the fish block to slam down on her right thumb and the machine, causing a partial amputation of the thumb tip.
An employee opened a fillet machine to remove a fish that had gotten stuck when their left hand made contact with the blade, resulting in cut ligaments between the thumb and index finger.
An employee was moving a loading ramp to the dock when the ramp became stuck. While dislodging it, the ramp fell on their left hand. The employee sustained a partial amputation to their left middle finger.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.