Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Milwaukee Electric Tool Corporation, 4355 Milwaukee Street, JACKSON, MISSISSIPPI 39209
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was operating a pneumatic press when it cycled and struck the employee's right little finger. The fingertip was amputated. The press was guarded at the time of the incident.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 335999)
An employee turned a corner while walking, tripped over the corner of a pallet on the floor, fell onto her arm, and broke it. She was hospitalized, requiring surgery.
An employee was moving a transformer from inside a shop. He was rolling it down a ramp when it tipped over onto his right foot and big toe, resulting in crush injuries and a laceration.
Employees were moving an electrical cabinet by using two wheeled equipment skates. One of the wheels of the skates became caught in a crack in the floor, causing the equipment to tip over and land on an employee's right foot. The employee's foot was fractured.
An employee was using an industrial magnet to lift and maneuver a weldment. While the frame was being set down on the welding table, the magnet disengaged prematurely; the frame fell and crushed the employee's left ring and middle fingers. The employee underwent medical amputations to the middle finger (at the first knuckle) and the ring finger (just past the second knuckle).
An employee was working on an order when they were struck by a forklift. This caused the employee to bump into a machine. The employee suffered a laceration to the right thigh, requiring hospitalization.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.