Injured by slipping or swinging object held by injured worker · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Blattner Energy Inc., 3003 US 283 North, BAIRD, TEXAS 79504
on — Fractures, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was using a torquing tool to torque down bolts on the blades in a wind turbine. As he began to tighten a nut, his finger became caught between the torquing tool and the wall of the hub. The employee sustained an avulsion fracture to a finger.
An employee was repositioning a crane to a different location when the crane tipped over onto its side. The employee jumped off the crane 10-12 feet to the ground below, resulting in multiple fractured back vertebrae.
An employee was aligning the butt section of a wind turbine when his left middle finger was struck by the reaction arm when it extended, resulting in amputation to the first knuckle.
An employee was removing bolts from a crane to disconnect the crane from a wind tower. When the crane was being lifted up, the employee's left hand caught on a bolt and was pulled into the bolt, resulting in an amputated thumb and ring finger.
An employee was using a dynamic cone penetrometer (DCP) tester when his left ring fingertip got caught between the weight and the top of the tool. The fingertip was crushed.
An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.
An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.
An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.
More severe injuries in this industry (NAICS 237130)
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.