Black River Commodities, LLC

An employee was cleaning a grain bin when his left foot was caught by the pull-off auger, resulting in the amputation of the foot.

An employee unhooked a grain wagon from a pickup truck. The wagon began to roll, and the employee's right ring and middle fingers were caught between the concrete ground and a piece of wood being used to stop the wagon from rolling. The employee underwent a revision amputation.

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.

An employee was de-weeding (by hand) under the base of a citrus tree and a rattlesnake bit her right hand.

On May 3, 2025, at approximately 8:45 AM, an employee was cleaning the surface of a sonic bag sealer with an emery cloth when the sealer activated and closed on their fingers. The employee sustained burns to three fingers on their right hand. The machine was not locked out at the time.

An employee was riding a manlift (elevator) up to the fourth floor of a building. His right leg was struck and pinched by the third-floor structure as he ascended. The leg was broken.

An employee had been using an air gun to blow cotton off the moving parts inside of the length/strength cabinet. The employee went to grab some cotton that was still stuck on the length/strength breaker bracket (above the rear jaw cylinder) when their left fourth finger became pinched. The employee sustained an amputation through the distal phalanx.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.