Puget Sound Naval Shipyard - Intermediate Maintenance Facility

On 11/22/2023, at 8:35 AM, an employee was stepping onto a barge when they slipped on a wet surface and fell on their knee. The employee sustained a torn ligament in their knee requiring hospitalization and surgery.

On November 6, 2023, an employee was hydroblasting mold-in-place (MIP), a rubber hole coating, from the outer hole of a submarine when pressurized water lacerated the employee's left foot. The employee was hospitalized.

An employee was walking to the clinic when they tripped on a chain used to keep vehicles out of the ambulance loading dock. The employee hit their elbow on the sidewalk, sustaining an open fracture to the left humerus.

At about 11:30 a.m. on May 28, 2020, an employee was clearing a clog from the classification system for a plastic media recovery system. When the clog cleared, the open adjustable rotor started to spin, causing amputations to the employee's left index, middle, and ring fingers (with bone loss to the furthest knuckle on the middle finger).

An employee was using a portable worm-drive circular saw to cut slots in 4X4 lumber for trailer stairs and cut their left middle finger resulting in a fingertip amputation without bone loss.

On 11/22/2023, at 8:35 AM, an employee was stepping onto a barge when they slipped on a wet surface and fell on their knee. The employee sustained a torn ligament in their knee requiring hospitalization and surgery.

After moving a barge lid, an employee was walking down the stairs on the barge when they slipped and fell approximately 15 to 20 feet, reuslting in a head injury.

An employee was using an excavator on a barge to scoop and remove fertilizer product stored in the cargo area. As the employee was transporting the skid-steer by chains and hoisting equipment from the dock to the barge, the employee fell approximately 10 feet off the skid-steer bucket to the cargo hold area below. The employee suffered a concussion.

Swingmen were performing discharge of an iron ore vessel. The discharge process consists of gathering remaining product into the center of the hold to facilitate removal by crane. At approximately 11:45 PM, a swingman was descending a ladder into a hold when he lost his footing and fell approximately 10-15 feet to the deck of the hold. The employee sustained fractures to their back and left leg.

An employee was on a bulk carrier ship. While removing lashing from wind turbine components, the employee lost balance and fell approximately 6 - 7 feet from a hatch to the deck of the ship. The employee was hospitalized with a head injury, and a fractured wrist, and required surgery.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was struck by a plasma cutter and suffered a broken left tibia and fibula. The employee was hospitalized.

An employee was preparing to bend a flat bar in a brake press. When the machine was jogged, the stock rotated up and crushed his left middle fingertip against the outer frame of the die. The fingertip was amputated.

An employee was cutting metal with a torch. A piece of metal struck the employee's left foot, causing multiple fractures to metatarsal(s). The employee was hospitalized.

An employee was descending a ladder carrying a bag of trash. He fell, landed on the ground about 10 feet below, and suffered fractures to his right hip and pelvis.

The injured employee was assisting a Department of Homeland Security (DHS) enforcement operation. During an apprehension, officers returned fire at a subject and struck the employee with a bullet. The employee sustained a gunshot wound to their right hand.

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

An employee was working on an electrical panel in a mechanical room when an arc flash occurred. The employee suffered burns.

At about 3:10 p.m. on October 3, 2025, an employee was inspecting a car. Two dogs that had been in another car were leashed and tethered to a bollard. As the employee inspected the first car along with a narcotics detection dog, one of the other dogs came loose and attacked the narcotics dog. The employee was separating the dogs when the other dog bit his left ring finger. The last joint of the finger was injured and part of it was bitten off.

An employee was preparing a bundle of green onions for chopping. While holding the bundle in his left hand, he made his first cut using a 9-inch kitchen knife held in his right hand. The knife contacted the tip of his left thumb, resulting in an amputation of approximately 0.5 inches of the thumb that required hospitalization.