KONE Elevators & Escalators

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee walked into the chairlift hoist way and the chairlift platform was not there. The employee fell 10-12 feet to the chairlift platform on the first floor. The employee sustained a fractured femur.

An employee was dumping trash into a compactor when he lost his balance and fell approximately 5 feet into the trash compactor. The compactor was not in use at the time. The employee was hospitalized with multiple fractures.

Employees were installing components of an elevator from inside the elevator and removed temporary hoisting equipment when the elevator descended from the fourth floor to the pit floor. One employee was hospitalized with fractures to their fibula and a rib, and the other employee was hospitalized with fractures to both feet.

An employee was standing on the edge of the dumpster while pulling out cribbage. The employee fell to the ground, sustaining a fractured elbow and hip. The employee was hospitalized.

An employee was using a magnetic drill to drill a hole on an elevator door. His left glove became entangled with the drill bit, which partially amputated his left thumb below the last knuckle and removed several inches of a tendon. The employee's left middle finger was also severely lacerated. He was hospitalized and received stitches.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.