Norton Metals

An employee was offloading containers from his truck using a deck that goes up and down. When the deck was up, he took a step and his foot went between the truck and the deck, resulting in a foot/ankle fracture.

An employee was using a hoist to lift large containers (420 pounds) of steel parts to be dipped into tanks. The employee set a container down on a support and his finger was caught between the container and the support, resulting in amputation just behind the first knuckle.

An employee was operating a riding mower. The employee's left hand became stuck between the mower's front left support bar and its reel. The employee suffered tendon damage to the middle three fingers.

An employee was guiding a motor into a container while a forklift was lowering it. The employee made contact with the motor, which amputated the top of his left thumb.

An employee was moving 4-inch square tubing from a pallet to a four-post rack when his right ring finger was caught between the end of a tube and the rack. The employee's finger was partially amputated.

A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.

An employee was on the deck of a trailer helping a customer unload tubes. The employee was working to place a cargo strap on the remaining tubes using a winch bar when it slipped off the tubing, causing him to lose his balance and fall headfirst onto the asphalt lot below. The employee suffered a contusion on his forehead, resulting in hospitalization.

An employee and a customer were unloading two rectangular tubes. The tubes were wrapped together. The plastic wrap was cut so that one tube could be picked up. As the employee was lifting the top tube, the other tube (still connected to the top tube) came down onto his hand and broke two of his fingers. He was hospitalized.

An employee was assisting as a forklift got pipe from a pipe rack. The employee was on one of the forklift's forks as it was raised to the top of the rack, a height of about 15 feet. He fell to the ground and suffered a dislocated and fractured right elbow.

On September 23, 2025, at approximately 7:43 p.m., an employee was using a knife to cut poly banding from a metal coil. The knife slipped, causing a laceration to the inside of their left arm at the elbow joint. The employee was hospitalized and required surgery to repair a damaged vein.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.