BOISE CASCADE

An employee was changing over from running 3 1/8 to 5 1/8 beams at the sander on the finish line and placed a 2x6 board under the sander side head. The machine grabbed the board, pulling their left hand into the sander side head and causing a severe laceration on the left index finger and thumb. The index finger was amputated.

An employee was removing veneer from a composer machine using a pipe pole. The employee made contact with the blade in the machine, which partially amputated the employee's left thumb. The employee was hospitalized.

An employee was working on a stud mill machine. The machine amputated the employee's left thumb, index finger, and middle finger.

An employee was attempting to clean the focus eye lens in a trough that wood passes through on the lay-up assembly line. The machine started while the employee's right ring finger was in the strike area and a piece of wood crushed the finger, breaking it and causing the fingertip to burst.

An employee was attempting to dislodge a piece of veneer that was caught in a machine when her glove was pulled into the drive gears in the lower in-feed belt. Her right index finger was pinched and smashed by the drive gears. The machine was running and guarded at the time of the incident.

An employee was riding on a powered pallet jack near a sewer drain. The pallet jack hit a dip near the sewer drain, and the employee s left foot hit a clamp truck parked in a charging station. He suffered a cut to the big toe, as well as fractures in the toe and the foot.

An employee went to step off material handling equipment to grab their jacket when the throttle of the vehicle engaged. The vehicle reversed and the employee's left foot was crushed between two material handlers, resulting in a fracture.

An employee was working at a height of approximately 20 feet and was standing outside his forklift's basket attachment. His forklift was struck by another forklift, causing the employee to fall to the warehouse floor below. The employee sustained facial injuries, broke two ribs and an arm, and also suffered a head injury. The employee was wearing a harness at the time but it was not connected to an anchor point.

On November 8, 2023, an employee was operating a stand-up pallet jack in the warehouse. As he was backing up, the pallet jack struck the basket of a parked aerial lift. His right ankle became caught between the pallet jack and the aerial lift basket resulting in a fractured ankle.

On October 26, 2023, at approximately 12:00 PM, an employee operating a four wheeler was on their way to an off-property break location. The employee stopped the four wheeler near the administrative office to allow a log truck to exit the property. The log truck backed up, and the employee's left ankle was caught between the log truck trailer and the four wheeler, resulting in a fracture and laceration.

An employee was walking down the off ramp from a box truck, carrying a door for delivery. A strong wind caught the door, causing the employee to lose balance and fall about 2 to 3 feet to the ground. He landed on his back and suffered a broken vertebra.

An employee was loading lumber from a rack into his truck by hand. He fell from the truck to the ground and sustained a fractured hip.

An employee was delivering lumber to a customer's job site. He was using a truck-mounted forklift to transport the material to the staging area. The surface of the path of travel changed from asphalt to soil and rock with a slight downward grade. When the forklift moved onto the softer surface, it sank into the ground and its center of gravity shifted forward, causing it to tip over. The employee's right arm sustained a closed, supracondylar humerus fracture.

An employee was helping two forklift operators move and inventory flat sheet metal that was staged on racks. The metal fell off one side and struck the employee's arms and abdomen. The employee sustained a laceration above the left eye, a left forearm injury, and a ruptured spleen. The employee was hospitalized and required surgery.

An employee was cleaning a press machine when their right ring finger became caught in the press, resulting in the amputation of the finger.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.