Pedestrian struck by vehicle backing up in work zone · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Jim Gilman Excavating, Inc., Hwy 287, TOWNSEND, MONTANA 59644
on — Fractures, affecting the leg(s), unspecified.
Final narrative
Employees were chip sealing a road. Two employees were working from the ground, moving a pile of chips, when a dump truck struck one of them as it backed up. The employee suffered a broken leg and was hospitalized.
A temporary employee was setting up a roadway construction zone. They were dropping cones from the back of a pickup truck. One of the cones fell and the employee exited the pickup truck to straighten the cone. The pickup truck then backed up and struck the employee causing rib and pelvis fractures.
An employee was walking backward, cleaning a roadway with a flat shovel. A rubber-tracked excavator, also backing up, approached the employee. Its tracks caught the employee's pants, which caused the employee to fall forward. The machine then caught the edge of the employee's foot. The employee suffered bruising to both feet and an ankle, as well as a bone chip on the front of the right heel.
An employee was directing traffic and performing clean-up activities at a site they were preparing for asphalt pavement. The employee was struck by a skid loader that was traveling in reverse, resulting in fractures to the left leg and hip. The employee was hospitalized.
A traffic control employee was assisting a homeowner who was backing out of their driveway when they were struck by an excavator traveling in reverse. The employee sustained a hip and foot fracture.
An employee was flagging for traffic control when he was struck by a truck that was backing up. The employee sustained a punctured lung and broken ribs.
More severe injuries in this industry (NAICS 324121)
An employee was stopping traffic at a job site so a piece of equipment could be moved to another location when he was struck by a car. It sent him in the air and he landed on his back, resulting in hospitalization with five fractured ribs, a fractured forearm, and a liver injury.
A truck of asphalt binder was being unloaded. An employee was checking the transfer hose connection on the truck. The gasket on the hose blew out, causing the asphalt binder to shoot out and burn the employee's face, neck, and arms.
A truck driver was on a platform, pulling a tarp on an asphalt load in a six-wheel dump truck. He fell from the platform to the ground and suffered broken ribs.
An employee was using a cutting torch to heat up bolts that had seized up. The bolts caught on fire in a flash burn, and the employee suffered burns to the arms and elbows.
On May 15, 2025, an employee was cutting down steel mesh and debris that was protruding from a milled roadway. As the employee began to cut a piece of steel with an angle grinder, he steadied himself with his left hand and the tool contacted the top of his left wrist, resulting in a laceration that required hospitalization.
An employee was fixing an issue with seed cleaning equipment when he slipped on the ladder he was on. He went to catch himself and his hand went into a moving belt and pulley on the cleaner. The employee sustained the amputation of his right middle and index fingertips just below the fingernails.
An employee was riding an all-terrain vehicle (ATV) to move a bison herd. He was riding up the side of a steep hill when the ATV struck a rock and rolled, ejecting the employee before rolling over him. The employee suffered broken vertebrae in his back that required hospitalization.
An employee was climbing in the spreader area to remove a pasta jam when his right little finger was cut by the rotary cut-off knife. The employee sustained a laceration and fracture, resulting in an amputation.
A smoke jumper parachuted out of a helicopter during a forest fire response, landed on steep rugged terrain, and suffered femur and rib fractures and a liver laceration. The employee was hospitalized.