105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Viking Lumber

Struck by falling part of powered vehicle still attached · Fractures

Federal OSHA recorded a severe workplace injury at Viking Lumber, 166 Searsport Avenue, BELFAST, MAINE 04915 on — Fractures, affecting the thigh(s).

An employee was performing maintenance on a truck lift gate when it fell on his leg, resulting in a broken femur.

Hospitalized Thigh(s) Truck-motorized freight hauling and utility, unspecified

Matthews International Corporation

An employee was fixing a mechanical casket lift in a vehicle when the lift came down on their left-hand fingers, resulting in amputation of two fingers.

Walgreens Distribution Center

An employee was helping to remove the clamp attachment paddles from a forklift so they could then repair a hydraulic leak. The clamp fell and pinned the employee's right ring finger against the mast. The employee's finger was partially amputated.

Beacon Building Products

An employee was on a truck attempting to stow an aluminum extension ladder onto the truck's conveyor boom system. As the conveyor mast was lowered, the boom control area came down on top of the employee's left foot, resulting in two toe fractures.

Frontier Forklifts & Services

An employee was standing on the elevated forks of a forklift to install the fork chain anchor nut. The employee slipped and as he went to catch himself, he accidentally engaged the up-down control for the forks. This caused the forks to fall onto his foot. The employee's right foot was crushed and all of his right toes were amputated.

United Rentals - Aerial

An employee was working on a scissor lift when a portion of the unit came down and struck their head at the lift base. The employee sustained a head laceration and a skull fracture.

The Home Depot USA, Inc.

An employee was unloading freight from a truck when a stack of doors fell over and knocked the employee to the ground. The employee sustained a fractured femur.

White Cap L.P.

An employee was performing rebar fabrication using a bending machine. The employee's glove became caught in the area where the rebar bend overlaps onto itself. The subsequent bending/cutting caused the two overlapping portions to squeeze together and amputate approximately 1/4" of his left index fingertip.

Builders Warehouse, Inc.

An employee was building wood detail blocking and a wood member needed to be resized. The employee took the wood member to the table saw and set the fence to the correct size. The employee pressed down on the board to control it when his left little finger contacted the running blade, resulting in an amputation.

Ready-Mix Concrete Incorporated

An employee was clearing a pipe along a culvert using a motorized plumbing machine. The end of the machine got tangled and stuck in long grass and other debris. The employee went to lift the end of the machine out of the grass and clear the blockage when his hand was pulled into the machine, resulting in a partial amputation and open fracture of his left distal phalanx.

Texas Building Supply

An employee was operating a router when it cut his right little finger, causing an amputation through the bone.

HB Fleming, Inc.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

GERRITY INDUSTRIES

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

O&P Glass

An employee was using a metal shear when it amputated the tip of his right index finger.

Cives Steel Company New England

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

Longroad Energy

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.