Caught in running equipment or machinery, n.e.c. · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at ABX Innovative Packaging Solutions, 7074 West Parkland Court, MILWAUKEE, WISCONSIN 53223
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was testing a resin piston pump used in a laminator. While holding the pump with one hand, he attached the air line to engage it. The pump pinched his finger; then, as he tried to use his other hand to free the finger, that hand was pinched as well. He suffered a finger amputation.
AmputationFinger(s), fingernail(s), n.e.c.Special process machinery, n.e.c.
More severe injuries at ABX Innovative Packaging Solutions
An employee's right arm was caught in an extruder, resulting in a broken arm, the partial degloving of their right hand and a facial laceration near their right eye.
Employees were assembling and testing a butterfly valve unit and actuator combo. When the unit was function tested with air, the valve gate closed on an employee's left thumb resulting in a fracture and laceration.
An employee was doing a daily inspection of the sifter screen on a mixer when the mixer line activated. The armature for the screen struck the employee's right wrist. Their wrist was cut and their hand was fractured.
An employee was doing a dry run during the setup of an ice cream machine. The machine indexed and the filler head amputated the employee's left middle finger above the last knuckle.
An employee was on a 3-foot ladder guiding cable onto a spool during installation on an overhead door. As the control box was jogged, the employee's hand was caught between the cable and spool, resulting in a wrist and hand fracture.
More severe injuries in this industry (NAICS 561910)
An employee was walking behind the rewind coding machine while on his phone. He rested his left wrist on top of the slitter bar and his finger came in contact with the roller, resulting in amputation.
The injured employee was assisting the bander operator with dressing units with dunnage. A unit became stuck on the conveyor. The injured employee was pushing the unit on the conveyor when a conveyor roller pulled his shoe in-between the rollers. The employee sustained crushing injuries to their left foot/toes.
An employee was inspecting and adjusting a tray in a thermoforming machine when the the trigger switch was touched, causing the machine door to close on their right hand. The employee sustained crushing injuries to the hand.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.