Metal-Matic, Inc.

An employee was using a jib crane to load coils onto a machine. He was helping to guide the coils when one slid back and pinched his hand between the hook/handle and another coil. The employee sustained a crush injury to the right hand and was hospitalized for surgery.

At about 9:00 a.m. on March 31, 2021, an employee was using an overhead crane to pick up steel tubing to put it into a tube cutter machine. As the employee reached to remove a tag affixed to the tubing, his left middle fingertip was amputated by the guide gate of the tube cutter.

On October 9, 2020, a furnace operator was unjamming a furnace and was overcome by carbon monoxide. The employee was hospitalized.

While operating a machine, an employee's hand went into a pinch point and the thumb tip was amputated.

An employee was preparing to unjam a machine when the machine cycled and amputated the employee's right index fingertip.

A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.

An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.

The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.

An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.

An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.

An employee fell onto a hot billet and suffered a burn to the left leg. The employee was hospitalized.

An employee was cutting wooden boards using a table saw when the glove on his left hand was caught by the blade, resulting in a partial fingertip amputation.

An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.

A crane was hoisting a pipe. An employee was adjusting twisted lifting chains on the end of the pipe when the pipe was raised, causing the employee's hands to be caught between the chains and the pipe. The employee suffered injuries to the left index finger, left ring finger, right ring finger, and right index finger; the right index fingertip was amputated without bone loss.

During a routine inspection, an employee placed their hand on a pipe to check a weld. The pipe clamp activated, closed on the pipe, and trapped the employee's right middle finger, resulting in a partial amputation and fracture to the fingertip as well as a laceration to the ring finger.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.