Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at FIMCO Inc., 1000 Fimco Lane, NORTH SIOUX CITY, SOUTH DAKOTA 57049
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
Employee 1 was operating a brake press when three fingers on his left hand were pinched between the part he was bending and the gooseneck punch of the brake press.
Employee 2 was operating a tube bender when his finger became caught between the mandrel and the die. The tip of his little finger was medically amputated.
Note to user: This record contains two separate events that were reported simultaneously to OSHA by the employer. These events are captured as one report.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333111)
An employee was climbing up a fixed ladder alongside a building to inspect a roof leak. The employee fell off the ladder and landed on the ground about 15 feet below. The employee was hospitalized with fractures to both wrists.
On September 16, 2025, an employee went to pull a weld stand when he tripped and fell, landing on the floor on his right hip. The employee suffered hip and fibula fractures that required hospitalization and surgery.
An employee was accessing a tensioned hook that required a hoist mechanism to be engaged. He was unhooking the lift hook from a shelf column when the "up" button was pressed, which released the tension on the pneumatic air hoist. The employee's right index finger was caught between the hook and the column, resulting in a soft tissue amputation and fracture to the fingertip.
A crane was lifting a pole out of a zinc bath in the galvanizing department when the chain attached to the pole broke. The pole fell back into the bath and liquid zinc splashed onto an employee, who suffered third-degree burns to an arm, the abdomen, the torso, the upper left side of the chest, an ear, the neck, and a hand.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.