Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Jagemann Stamping Company, 5757 West Custer Street, MANITOWOC, WISCONSIN 54220
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was operating a steel press when the die came down on their right hand resulting in amputation of their middle fingertip and amputation of the ring finger at the second knuckle.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 336370)
An employee was verifying light curtain function at a load cell tester when their right index finger was amputated by a hydraulic cylinder above the middle knuckle.
An employee was positioning an overhead crane to stand up a skidded coil when the coil swung back. The employee was caught between the swinging coil and another coil sitting on a coil pad, resulting in hospitalization due to a loss of consciousness and a pelvic injury.
An employee was performing general cleanup duties when they collapsed and passed out due to heat exhaustion. They were hospitalized for heat exhaustion, dehydration, and acute renal failure.
A temporary employee was helping a forklift operator by holding metal sheets to steady them as they were placed on a rail for feeding to a stamp machine. The operator lowered the forks with the blanks (weighting approximately 750 pounds). The temporary employee's right index finger was caught between the metal and the feeding rail. The finger was crushed and partially amputated through the bone.
An employee was using a mechanical trim press to trim flash off metal parts. The employee was loading a part to be trimmed when the press cycled and crushed the index fingers on both of their hands. The employee sustained a fingertip amputation. The machine was not guarded at the time.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.