Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Norfolk Iron and Metal, 1701 E South Avenue, EMPORIA, KANSAS 66801
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was using an overhead bridge crane to move steel sheet and plate material from the floor to a trailer to be shipped. The employee's hand got caught in a chain that was part of the lifting device, resulting in broken ring and middle fingers, as well as a little finger amputation.
At the tube blazer machine area, an employee was repositioning a piece of 24-foot metal tube material. The employee was using a metal bar to push against the tube when the metal bar slipped off the tube and struck the right side of their jaw. The employee was hospitalized with a fractured jaw.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 441310)
An employee was carrying a plastic tote full of brake rotors. His foot caught the corner of a pallet, causing him to fall to the concrete floor and break his hip.
An employee was working on a vehicle in a bay. As he turned around, his foot caught on the leg of a lift and he heard/felt a snap and pop in his right hip and fell. The employee sustained a torn hamstring in his right leg.
An employee was installing a driveshaft on a customer's vehicle. He was using a floor jack to hold the driveshaft in place to line up the bolts. The driveshaft moved off the jack and crushed his left ring fingertip, resulting in an open fracture of the tuft of the distal phalanx, as well as a partial amputation.
An employee was in a truck, helping a team lift a 55-gallon drum into the truck. The employee fell to the ground and suffered a broken left arm. The employee was hospitalized and required surgery.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.