Direct exposure to electricity, unspecified · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at IEA Constructors LLC, 205 Firetower RD., ELKO, GEORGIA 31025
on — Electrical burns, unspecified, affecting the chest, except internal location of diseases or disorders.
Final narrative
An employee was conducting quality control work on installed solar panels when they were shocked while splicing wires to the solar panel, resulting in a burn across their chest.
HospitalizedChest, except internal location of diseases or disordersElectric parts, unspecified
An employee was feeding hay into a mulch grinder when his left hand became entangled in the bailing twine resulting in a fracture and amputation to the tip of his middle finger.
An employee was preparing a wind turbine hub for installation at a wind farm. While the hub was being lifted, the fixture and dunnage that it was sitting on shifted and contacted the employee causing lacerations to his left index finger and right thigh.
An employee was rigging a windmill blade bearing in order to remove old grease fittings. One side of the blade bearing was lifted off the ground to facilitate access. The swivel-eye bolt failed and the bearing fell, striking the employee's foot.
An employee was spotting for heavy equipment during a brush clearing operation. While a debris pile was being moved, bees (from a beehive in the pile) stung the employee's head and arms.
An employee was using a 5-foot ladder to access a work area. A piece of a component the employee was holding came loose, causing the employee to lose his balance and fall backwards to the ground 55 inches below. The employee suffered broken ribs and a laceration to the lower left leg, about 6 inches above the ankle.
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 237990)
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.
Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.
A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.
An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.