BLATTNER COMPANY

An employee was moving crane mats when he slipped and fell. He suffered fractures to three vertebrae in his back.

An employee was preparing a tank car for loading while chipping away solidified product in the manway opening of the tank car. A pressure noise within the tank car startled the employee, causing him to stumble backward and fall approximately 10 feet over the guard railing at the chemical loading rack to the ground. The employee suffered fractured vertebrae, a fractured right wrist and ankle, and a dislocated jaw.

An employee was installing an electrical tray remover from a ladder. As he was descending, his missed a step and fell 6-7 feet to the floor. The employee suffered a head injury.

Two employees were installing spray foam insulation in the attic of a new residential construction. The injured employee fell 8 feet from an A-frame ladder to the floor. The employee suffered lacerations, abrasions, and a head injury.

An employee was on a raised platform attaching wires to electrical boxes. The employee fell approximately 8 feet to the floor below and struck an exit sign on the way down, resulting in an injury to his face.

An employee was in a forklift man basket fixing a garage door opener when they fell approximately 8 feet to the concrete ground below. The employee suffered head and back injuries as well as kidney bruising.

An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.

An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.

An employee was working to move a telephone pole when the pole rolled, causing injury to their hip.

An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.

An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.

An employee was walking in a garage toward her delivery vehicle. As she stepped down a curb near her vehicle, she fell and landed on the concrete garage floor, resulting in a hip injury that required hospitalization.

Employees were performing maintenance operations on a railroad line when the machine experienced a load conveyor motor failure. While clearing the machine to allow for repairs, an employee pinned the left side of the swing conveyor. The operator on the right side then requested a slight bump to the left to align the right side for pinning. Once the swing was in position, the operator went to pin the right side and the chain tensioner failed, resulting in an abrupt release of the swing chain. The chain snapped back and struck the operator s right hand, resulting in a 1-inch laceration and a fractured fifth metacarpal. The employee was hospitalized and required surgery on the hand.

At about 9:15 a.m. on March 10, 2025, an employee was riding along a hardpack snow-covered roadway on a snowmobile. The snowmobile went over a berm and tipped/rolled, causing the employee to fall to the ground. He suffered a collapsed left lung and was hospitalized.

An employee was decommissioning a substation. The tower switch was being set down on the ground when the switch blade moved. The employee's finger was crushed and amputated.

An employee was struck by a truck and sustained a broken right leg.