Direct exposure to electricity, greater than 220 volts · Third or fourth degree electrical burns
At a glance
Federal OSHA recorded a severe workplace injury
at Hawthorne Contracting, Wideman Rd, OXFORD, ARKANSAS 72565
on — Third or fourth degree electrical burns, affecting the multiple body parts, n.e.c..
Final narrative
An employee was in a bucket installing a fiber optic line. An insulator 4 feet above the employee broke, causing the primary electric line to come loose and fall on him. He suffered third-degree electrical burns to the back, chest, arms, and hands. He was hospitalized.
HospitalizedMultiple body parts, n.e.c.Power lines, transformers, convertors
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee was installing conduit when they fell from the step ladder to the ground and sustained a wrist injury that required hospitalization and surgery.
On March 27, 2025, an employee was stringing up a wire drawing machine when his right little finger became caught between the wire and the capstan wheel on the machine, resulting in a fingertip amputation.
An employee was working on a press head and cylinder when his fingertips were pinched between a pin and cylinder. The employee sustained the amputation of his fingertips.
An employee was changing out a propane cylinder on a powered industrial truck when liquid petroleum gas contacted his hands. The employee sustained second-degree burns to his hands.
An employee was loading a reel into a take-up when the arbor arms came down on their right middle finger and it was caught between the dog pin and the drum. The employee sustained a fingertip amputation.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.