Direct exposure to electricity, greater than 220 volts · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at AUTOMATEDPOWER, Inc., Nissan Plant Main Substation, Close to Entergy Substation, CANTON, MISSISSIPPI 39046
on — Electrical burns, unspecified, affecting the upper and lower limb(s).
Final narrative
An employee contacted a bus bar while cleaning the inside of an electrical substation switch gear. The employee sustained burns to a hand and leg.
HospitalizedUpper and lower limb(s)Switchboards, switches, fuses
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee was cutting wire when his gloved left hand got pulled into the counter on the wire machine resulting in amputation of his left little finger and a laceration to his right ring finger.
An employee reached under a raised truck to pull on the spare tire when the jack slipped, causing their hand to be caught between the fallen truck and the spare tire. The employee was hospitalized with a severe injury to the right hand.
An employee was replacing a hydraulic cylinder on a mini-excavator. The employee was positioning the machine while it was in a trailer when their right leg became pinned between a track and the trailer, resulting in severe lacerations to the lower leg.
An employee was using an 8-foot folding ladder to retrieve a 250-foot coil of wrapped wire on a shelf. The employee dropped the wire which struck the ladder, causing the employee to fall from the ladder to the concrete floor. The employee sustained a skull fracture, a right knee fracture, and a rib fracture.
Four employees were moving a wooden spool of fiber-optic cable fiber when the injured employee slipped and fell, twisting his ankle. The employee suffered three fractures to his ankle.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.