Struck by or caught in swinging door or gate · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at County Materials Corp, 3019 West Prospect Avenue, APPLETON, WISCONSIN 54914
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was closing the security gate to the yard at the end of his shift when his left ring finger contacted the roller on the upper rail of the gate, resulting in a fingertip amputation near the nail bed.
An employee was measuring the elongation of a pre-stress cable strand. The strand failed under tension and hit the employee's right arm and hand. The hand was injured and two fingers were fractured.
An employee had been removing formwork to set up for a different job and was struck by the concrete formwork and sustained a broken pelvis requiring hospitalization.
An employee was attempting to close the safety clasp on a lifting hook when his right middle finger became stuck in the clasp and was partially amputated.
An employee was guiding a hydraulic cylinder ram into its storage rack while it was supported by a small jib crane. As he was guiding the cylinder, the ram slowly retracted. The head of the ram then pinched the employee's finger against the bolt and the frame, crushing and partially amputating his right index finger.
An employee was doing a repair in an office building. He was closing a bank vault door when his right index finger became caught between the door and the door frame resulting in amputation of the fingertip.
An employee's left index finger was pinched between a cattle gate and a concrete wall, resulting in amputation of soft tissue and loss of the fingernail.
On December 11, 2023, an employee was transporting equipment for demolition tasks and waiting for the superintendent to open the door. The door closed and amputated the tip of the employee's left thumb.
More severe injuries in this industry (NAICS 444110)
The injured employee was walking through the warehouse. Another associate was driving a forklift with a pallet of large format tile (slabs) when the slabs began to tip. The injured employee ran over to stop the slabs from falling, but the slabs fell on his lower left leg/foot. The employee sustained fractures in his lower leg and foot. He was hospitalized and required surgery.
An employee was doing a cutback on a piece of lumber using a chop saw. The saw hit a knot, the piece of lumber buckled, then kicked back and broke the kickback guard. The board was then pulled back into the blade, which lacerated the employee's left index and middle fingers.
On October 16, 2025, an employee was entering a parking lot after completing their work shift when they were struck by a vehicle being operated by a customer. The employee fell backward from the impact and the back of their head struck the asphalt. The employee was hospitalized due to brain bleed and a skull fracture.
On September 24, 2025, an employee was using a sledgehammer to straighten the forks on a forklift when a piece of metal broke off the fork and became lodged in the employee's leg. The employee was hospitalized.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.