Caught in or compressed by equipment or objects, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at County Materials Corp., 702 N Edwin St, CHAMPAIGN, ILLINOIS 61821
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was guiding a hydraulic cylinder ram into its storage rack while it was supported by a small jib crane. As he was guiding the cylinder, the ram slowly retracted. The head of the ram then pinched the employee's finger against the bolt and the frame, crushing and partially amputating his right index finger.
AmputationFinger(s), fingernail(s), unspecifiedSpecial process machinery, n.e.c.
An employee was measuring the elongation of a pre-stress cable strand. The strand failed under tension and hit the employee's right arm and hand. The hand was injured and two fingers were fractured.
An employee was closing the security gate to the yard at the end of his shift when his left ring finger contacted the roller on the upper rail of the gate, resulting in a fingertip amputation near the nail bed.
An employee had been removing formwork to set up for a different job and was struck by the concrete formwork and sustained a broken pelvis requiring hospitalization.
An employee was attempting to close the safety clasp on a lifting hook when his right middle finger became stuck in the clasp and was partially amputated.
An employee was changing mud cups in the hopper cylinders of a concrete pump truck. The cylinders moved and three of the employees fingers were amputated.
An employee was standing on the rig floor next to a polishing unit. His hand was placed on the polishing unit when the pump was lowered, resulting in amputation of their right thumb, ring, and middle fingertips.
An employee was using air to blow out the air wash to the blender and grinder station. As the employee reached to verify that the air wash was clean, the unit pinched and amputated their fingertip.
An employee was retrieving a lost drill pipe with a lifting bail when their left thumb got pinched between the table and handle of the lifting bail while trying to re-thread the pipe to lift it out. The employee suffered an amputation to the left thumb.
An employee was removing a core chuck from a stationary roll when their right ring finger was pinched between the chuck and the roll. The employee's fingertip was amputated.
More severe injuries in this industry (NAICS 327320)
An employee was walking through the garage and stepped on a mechanic's creeper. His feet went out from under him and he fell, sustaining a fractured right femur.
An employee was exiting a loader and coming down the ladder. His hand slipped off the railing and he fell backward onto sandy ground, landing on his side. The employee was hospitalized with a fractured pelvis and a rotator cuff tear.
A concrete mixer truck driver was walking up the stairs of the slump rack. They fell from the slump rack platform and landed on the ground in the wash-out area. The employee sustained fractures to their left scapula and lower back vertebrae.
An employee backed their concrete truck into place to begin unloading it into a concrete pump unit. He exited the vehicle, and went to the rear to unload. When he began unloading, the truck rolled backward and pinned him against the pump unit. The employee sustained fractures to their pelvis, both femurs, both tibias and fibulas, and their left ankle.
A mechanic was changing out an air spring on a concrete mixer truck cab. The air spring was receiving higher air pressure than it was designed to use, because of a faulty level check valve. This increased pressure caused the air spring to burst. Its top portion separated and struck the employee's left forearm, causing a laceration and fracture. The employee was hospitalized, requiring surgery.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.