LALA Branded Products, Inc.

An employee was working in a robotics cell when several fingers on their left hand made contact with a conveyor and were crushed, resulting in the surgical amputation of at least one finger.

An employee was pulling hose to connect to a pump when his hand slipped and his left middle finger struck the moving impeller of the pump. His finger went down the intake pipe and his left middle fingertip was amputated.

An employee was operating a forklift and unloading a truck. After the truck was unloaded, the employee got off the forklift and proceeded to adjust the dock plate with a hook tool. The dock plate slipped and the employee went to adjust the plate with their hand when their left middle finger got caught. Their finger was amputated above the first joint.

An employee was rotating a carbide granulator blade when his finger was caught between the blade and a stationary part of the machine. The employee's right middle finger was partially amputated and they suffered an avulsion to the right ring fingertip.

An employee was using a CNC metal lathe machine in manual mode to check that the thread blocking tool made contact with the jaws. As the employee was manually spinning the spindle, his index fingertip was crushed between the spindle's jaws and the grooving insert, resulting in a fingertip amputation.

During a material handling operation, an employee's fingertip was caught under an air conditioning unit as the unit was lowered onto a cart. The employee's fingertip was amputated.

An employee was removing a bolt from a tractor hub when their right index finger was caught between the hub and the frame. The employee's fingertip was crushed and the employee was hospitalized.

An employee was using an end mill to mill out a section of a metal door frame that he was fabricating. Metal shavings built up and he could not see the marking to cut, so he used a small brush to remove the shavings. While brushing off the shavings, his glove became caught in the spinning mill bit and pulled his hand in. The employee's right index finger contacted the spinning bit, resulting in a partial amputation to the side of the finger.

An employee was unjamming cookie dough from a machine when the rotating pump caught her left index and ring fingers, resulting in fingertip amputations.

An employee was marking a malfunctioning mold when their finger got caught between one section of rollers on the mold and the guarding on the next section of rollers. The employee's finger was amputated below the nailbed.

An employee was exiting the rear door of a freezer truck when he slipped/misstepped and fell to the ground. The employee sustained a broken right leg that required surgery.

An employee was palletizing ice cream when his fingers got caught in a chain and sprocket, resulting in amputations of the middle and ring fingers.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.