LALA Branded Products, Inc.

An employee was racking products. The employee's little finger was crushed between a pallet jack and a structure. The employee suffered broken bones and damage to the fingertip.

An employee was pulling hose to connect to a pump when his hand slipped and his left middle finger struck the moving impeller of the pump. His finger went down the intake pipe and his left middle fingertip was amputated.

An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was working on a production line. The employee went to retrieve parts that came out of the parts holder, and their left hand became caught between a chain and a sprocket. Three fingers on the hand were amputated.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a pad printer. The employee's finger was caught in the printer and they suffered a fingertip amputation. The part of the printer that caught the employee's finger was unguarded at the time.

An employee was using an end mill to mill out a section of a metal door frame that he was fabricating. Metal shavings built up and he could not see the marking to cut, so he used a small brush to remove the shavings. While brushing off the shavings, his glove became caught in the spinning mill bit and pulled his hand in. The employee's right index finger contacted the spinning bit, resulting in a partial amputation to the side of the finger.

An employee was unjamming cookie dough from a machine when the rotating pump caught her left index and ring fingers, resulting in fingertip amputations.

An employee was marking a malfunctioning mold when their finger got caught between one section of rollers on the mold and the guarding on the next section of rollers. The employee's finger was amputated below the nailbed.

An employee was exiting the rear door of a freezer truck when he slipped/misstepped and fell to the ground. The employee sustained a broken right leg that required surgery.

An employee was palletizing ice cream when his fingers got caught in a chain and sprocket, resulting in amputations of the middle and ring fingers.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.